MP300 MX1 
接触型スマートカードパーソナライゼーション

MP3000 MX1は、高性能パーソナライゼーションカプラを探しているすべてのスマートカードメーカーおよびスマートオブジェクトメーカーに対するマイクロプロスからの答えです。

  • 主な機能
  • 対応プロトコル
  • パラメータ
  • 利用可能な試験

MP300 MX1の主な機能

  • Personalisation of 3 contact devices simultaneously
  • All 3 devices are handled in a fully independant manner
  • Support of SWP, USB and SD protocols is optionnal
  • Fully compatible with ETSI TS 102 613 and ETSI TS 102 622 specification
  • Continuity test feature, for a first level of quality inspection
  • Open API : possibility to implement custom protocols
  • Physical parameters flexibility : possibility to program the Vcc and the Clock values
  • Can be combined on the same MP300 mother board with another MP300 MX1 (6 simultaneous heads) or with a MP300 MCL1 for 3 dual interface couplers

対応プロトコル

ISO/IEC 7816-3
– T=0 and T=1 protocols : 100% implemented, managed by Firmware and FPGA, accelerated by hardware

SWP/HCI (ETSI TS 102.613 and ETSI TS 102.622)  (optionnal)
– SWP transmission : Assisted by hardware
– LLC layers support : ACT, CLT, S-HDLC realised by firmware

USB 2.0 (optionnal)
– Available speeds : Low speed, full speed
– Classes : ISO/IEC 7816-12, mass storage, custom protocols

Synchronous chips
– Support of all kind of memory components (SLE 46xx, T2G, …)

SD/MMC 4.1 (optionnal)
– Data bus : 1 and 4 bits
– Low level commands : Available

Raw mode
Implementation of custom protocols and support of out of standard chips

プログラム可能なパラメータ

Physical parameters
– Voltages
– Vcc : Adjustable from 0V to 6V
– Vol/Voh : 0V   /   1.55V to 5.8V
– Clock frequency
– ISO 7816 clock :
– Adjustable from 10kHz to 50Mhz
– Duty cycle : 50%
– Pin states
– All pins can be managed separately

ISO 7816 communication parameters
– Adjustable parameters : All normative timings (WWT, BWT, CWT, …), parity, pull-up resistor

SWP communication parameters
– Available baudrates : 212 kbps
– Adjustable parameters : Activation time, P2, P3 parameters

USB-IC parameters
– Voltage classes supported : 1.8V and 3.0V

利用可能な試験

Continuity test :
– Inspects the overall connection from the output of the coupler to the smart card connection.
– Simular to Open/short test

Related posts